This page provides a solution to use Doorbell 6 with Fibaro HC2/HCL and forms a part of the larger Doorbell 6 user guide.
To use the siren in HomeCenter Lite, please download the Virtual Module and integrate it into your HomeCenter Lite.Download: Virtual Module
1.1. Open your browser and log in to your HomeCenter 2/lite interface.
1.2. Pair/Include the Doorbell 6 as described in the manual.
1.3. Go to the "Devices" page.
1.4. Press the button "Add or Remove device" on the left side.
1.5. Select the enclosed file via selection field and confirm with open.
1.6. Then go back to "Devices".
1.7. Now you'll find Doorbell 6 listed under this page.
1.8. Open Doorbell 6 settings by pressing the small wrench icon.
1.9. Determine the Device ID of your Doorbell 6 listed under "ID:" and record it.
2.1. Open the configuration of your Virtual Module.
2.2. Change the tab to "Advanced".
2.3. Add in the line "IP-Address" 127.0.0.1
2.4. Add in the line "TCP-Port" 11111
2.5. Scroll down and change the following settings:
2.5.1. DEVICEID: Add the Fibaro Device ID (see point 1.9).
Note: You must assign the device ID of the respective child device to each ON/OFF key pair.
- Sound 1 ON = Device ID 3666
- Sound 1 OFF = Device ID 3666
- Sound 2 ON = Device ID 3667
- Sound 2 OFF = Device ID 3667
188.8.131.52. Go to Webpage BASE64 Encode
184.108.40.206. Enter your username and password separated by a colon from Home Center access and press Encode Base64
220.127.116.11. Replace the placeholder with the encrypted user name and password for all buttons
2.6. Press save on the right side and test the virtual module.
3. Using in Block Scenes
3.1 Create a new Block Scene
3.1.1 Select your trigger
3.1.2 Now select "Virtual module" as the device to be triggered and the associated button
3.1.3 Save the scene