This solution will guide you through programming your Aeotec Home Energy Meter Gen5 (ZW095) to report all energy reports to your HomeSeer network. This page forms part of the larger Home Energy Meter Gen5 user guide. Follow that link to read the full guide.


Pair HEM Gen5 V1.35 or V1.04 using non-secure
1. Unpair HEM Gen5
2. Re-pair HEM Gen5 using "Non-secure" pairing via HomeSeer interface (don't use regular pairing)

Changing Parameter settings
1. Access the root of the HEM Gen5
2. Go to Z-Wave tab -> Settings.
3. Input these parameter settings individually at the bottom:

Parameter 2 [1 byte] = 0 //disable solar
Parameter 3 [1 byte] = 0 //disable threshold
Parameter 13 [1 byte] = 1 //enable CRC16 encapsulation (HomeSeer requires this)


1 Clamp Settings

Parameter 101 [4 byte] = 592143 //report all reports on clamp 1 via group #1
Parameter 111 [4 byte] = 240 //Set the time of report for group #1


2 Clamp Settings

Parameter 101 [4 byte] = 1776384 //report all reports on clamp 1 + 2 via group #1
Parameter 111 [4 byte] = 240 //Set the time of report for group #1


     3 Clamp Settings

Parameter 101 [4 byte] = 4144911//report all reports on clamp 1 + 2 + 3 via group #1
Parameter 111 [4 byte] = 240 //Set the time of report for group #1


4. Save this.
5. If you are still not getting any readings, move onto the association section below, this would indicate that Group Association 

Association (steps for is your HEM Gen5 is still not reporting)
1. Access the root of the HEM Gen5
2. Go to Z-Wave tab -> Association.
3. Click on "Update" button
4. Click on "X" on Node #1 under "Group 1"
5. Now click on "Update" button again.
6. Input this into

"Device to be Controlled" -HomeSeer
"Destination Endpoint" -(No Endpoint)

7. Now click on "Add Association"