Connecting Water Sensor 7 (Basic) or Water Sensor 7 Pro  to Home Assistant requires a working installation of that software with Z-Wave management being handled by Aeotec's Z-Stick platform. Once connected to Z-Stick and Home Assistant with Z-WaveJS to MQTT, Door / Window Sensor 7 will offer the following features for either product:


Water Sensor 7 Gen7 (ZWA011)

  • Water Alarm
  • Home Security - Tamper
  • Battery level


Water Sensor 7 Pro Gen7 (ZWA012)

  • Water Alarm
  • Humidity
  • Air Temperature
  • Home Security - Tamper
  • Battery level



Steps to pair Water Sensor 7 to Home Assistant.

  1. Open Home Assistant Interface: http://homeassistant:8123/
  2. Click on "Configuration" at the bottom left of the page.
  3. Click on "Integrations"
  4. Click on "Configure" under your Z-Wave JS integration.
  5. Click on "ADD NODE"
  6. Click on "START INCLUSION"
  7. Open the cover of your Water Sensor 7




  8. Now tap the small black tamper switch 3x quickly on Door Window Sensor 7.



  9. Allow about 1-2 minutes to allow your Home Assistant to scan the device information and populate the correct device information about it. 




How to exclude Water Sensor 7 from Home Assistant.

  1. Open Home Assistant Interface: http://homeassistant:8123/
  2. Click on "Configuration" at the bottom left of the page
  3. Click on "Integrations"
  4. Click on "Configure" under your Z-Wave JS integration
  5. Click on "REMOVE NODE"
  6. Click on "START EXCLUSION" - Your Home Assistant should start scanning for device button presses.
  7. Open the cover of your Water Sensor 7



  8. Now tap the small black tamper switch 3x quickly on Door Window Sensor 7.



  9. Home Assistant will stop scanning for devices excluded (if not paired), if a device is paired, it will state which device it was removed. Reload the page, and you should notice one less device node under "Nodes ready".




Troubleshooting


Having issues pairing your device?

  • Move your Sensor within 4 - 10 ft of your Home Assistant Z-Wave network.
  • Remove power from Water Sensor 7 for 1 minute, then power it up again.
  • Try factory resetting or excluding your Water Sensor 7.
    • Exclude first in case the device actually paired to Home Assistant otherwise it will leave a phantom device in your network that will be difficult to remove.
    • Perform a manual factory reset
      1. Remove the cover of your Water Sensor 7
      2. Press and hold the tamper switch for 5 seconds until the red LED blinks.
      3. Quickly release the tamper switch, and then immediately press and hold again
        • If successful, the LED will display a solid green LED.