This page contains the firmware update files for Recessed Door Sensor 7 and form part of the larger Recessed Door Sensor 7 user guide. 

Changelogs

  • Resolves Supervision CC session ID when paired with S2 Authentication


Download Recessed Door Sensor 7 V1.05


Before you update


Please make sure you download the correct Z-Wave Frequency and begin the update with the sensor as close as 10ft / 3m distance to your hub.


Update with an existing Z-Wave hub


In order to use the GBL update files, your Z-Wave gateway must support OTA firmware update. If supported, follow the steps from your Z-Wave Gateway to firmware update your sensor.


Update using a Z-Wave USB Adapter


If your software does not support .GBL files yet, you can use PC Controller 5 (connected to any standard Z-Wave USB Adapter) by SiLabs to firmware update with GBL files. This software is a Windows exclusive.

You can find that PC Controller 5 here through Simplicity Studio: SiLabs Simplicity Studio


Following the update below, make sure that you have your Recessed Door Sensor 7 at least 10ft from your Z-Wave USB Adapter during the update to avoid any failures.

  1. Follow the steps outlined here to get access to Simplicity Studio and PC Controller 5: https://help.aeotec.com/support/solutions/articles/6000226205-z-wave-command-class-configuration-tool-download-
  2. Download the correct Z-Wave Frequency firmware update for your Recessed Door Sensor 7.
  3. Open up Z-Wave PC Controller software through Simplicity Studio
  4. Plugin your Z-Wave USB Adapter
  5. Click on the "Gear" icon and select the COM port your Z-Wave USB Adapter is connected to.
  6. Click on "Network Management"
  7. Click on "Remove", then tap the button on Recessed Door Sensor 7.
  8. Click on "Add",  then tap the button on Recessed Door Sensor 7.
  9. Deselect all security options (this will help speed up your firmware update process), then press OK.
  10. Click and highlight your new Recessed Door Sensor 7 Node.
  11. Click on the Home icon button on the top left corner.
  12. Click on OTA Firmware Update.
  13. Ensure your Recessed Door Sensor 7 node is highlighted, then press Get.
  14. Wakeup your Recessed Door Sensor 7.
    • Press and hold its Action button until its LED lights up, then release.
  15. Under Firmware Update, click on the folder icon.
  16. Then select the firmware update file you downloaded on step 2 of these instructions, then click Open.
  17. Highlight Target 0 (under Firmware Targets:).
  18. Then click on Update.
  19. Wakeup your Recessed Door Sensor 7.
    • Press and hold its Action button until its LED lights up, then release.
  20. Wait a few minutes while you wait for the firmware update to finish.